Resetting the DTP22

It is possible to return the X-Rite DTP22 to its factory defaults. Doing so will return the unit to a known functional state before attempting to configure it for the specific needs of a software application. The reset command will restore ALL settings in both volatile and non-volatile memory. Use this command with care as it overwrites all configuration settings in the instrument.

Required... (1) X-Rite's reset utility or (2) any commercial terminal program. Proceed as follows:

• Set terminal to the correct port, baud rate, handshake etc.

         Default: 9600 baud, 8 data bits, 1 stop bit, no parity, handshake off

• Confirm communication by sending a "SV" command.

         Instrument type and firmware version should be returned.

• Send the reset command:

         Send "5CRI". Response should be <00>

Unit is now returned to X-Rite Factory Default Settings.

Note: After a reset, the unit must be recalibrated before it will measure accurately!