Epson Stylus "Photo" 750 and the 390

If your densitometer has a "Stylus" I/O preset, select it now. If "Stylus" is not an option use the "CANON1" setting. There is nothing to configure on the printer! It will operate correctly (out-of-the-box).

In the event the printer becomes misconfigured, the following steps will reset the device to factory (out of the box) conditions:

• Turn printer off.
• Press and HOLD both the "Load/Eject" and the "Cleaning" buttons.
• WHILE holding these two buttons, turn the power back on - - continue to hold!
• Count slowly to five (5 seconds).
• Release the two buttons and then press and HOLD just the "Load/Eject" button alone.
• Continue to hold "Load/Eject" until the printer lights flash and then release.

The printer is now returned to factory default settings.

Note: In December of 2000 it was found that several of the serial to parallel cables had been incorrectly wired. This is evidenced by a "Check Printer" warning on the densitometer. These cables will still function but enabling communications requires a single change in the densitometer. After saving either "Stylus" or "CANON1", return to the configuration page and using Custom Presets, change "PIN5" to "BUSY". (12/22/2000 jgm)