Calibrating the ATS / ATD Track

Calibration is an essential part of the maintenance procedure that helps insure accurate and repeatable results from your scanner.  To calibrate the ATS or ATD track,  follow the steps below.

  1. Make sure the track is clean.  To clean the track, spray the surface with glass cleaner and wipe down.  Follow up with a clean dry cotton cloth.  Do not use any chemicals, oils, or soap.  

  2. Click on the 'Instrument' drop down menu.

  3. Click on 'Scanning' and then click on 'Calibrate Track'.

The calibration procedure will take a few seconds or so......All done!

Questions? Need a Quote? Contact Us.  1.800.248.9748